Infrared Board Cable - HP ENVY x360 13 Maintenance And Service Manual

Infrared board cable

Table 5-12 Infrared board cable spare part information
Description
Infrared board cable
Before removing the infrared board cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. System board (see
Remove the infrared board cable:
1. Release the ZIF connector (1) to which the infrared board cable is connected, and then disconnect
the infrared board cable from the infrared board.
2. Remove the infrared board cable (2).
Reverse this procedure to install the infrared board cable.
Bottom cover on page
Battery on page 33)
Solid-state drive on page
Fan on page 38)
System board on page
30), and then remove the following components:
35)
58)
Component replacement procedures
Spare part number
L94507-001
63