Power Connector Cable - HP ENVY x360 13 Maintenance And Service Manual

Power connector cable

Table 5-6 Power connector cable spare part information
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the display assembly (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
52 Chapter 5 Removal and replacement procedures
Bottom cover on page 30).
Display assembly on page
Spare part number
L94512-001
40).