Solid-State Drive - HP ENVY x360 13 Maintenance And Service Manual

3. Disconnect the WLAN antenna cables (2) from the WLAN module terminals.
NOTE:
WLAN antenna cable connects to the WLAN module #2/Aux terminal.
4. Remove the Phillips M2.0×3.0 screw (3) that secures the WLAN module to the system board.
(The WLAN module tilts up.)
5. Remove the WLAN module (4) by pulling the module away from the slot at an angle.
NOTE:
Reverse this procedure to install the WLAN module.

Solid-state drive

Table 5-4 Solid-state drive spare part information
Description
1 TB, M.2 2280, PCIe, NVMe-3×4, SS solid-state drive with TLC
1 TB, M.2 2280, PCIe, NVMe, value solid-state drive
512 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
256 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive
128 GB, M.2 2280, PCIe, NVMe, solid-state drive with TLC
Before removing the solid-state drive, follow these steps:
The #1/white WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/black
WLAN modules are notched to prevent incorrect installation.
Spare part number
L85348-005
L85370-005
L85360-005
L85364-005
L85350-005
L85354-005
L90345-005
Component replacement procedures 35