Infrared Board - HP ENVY x360 13 Maintenance And Service Manual

Infrared board

Table 5-13 Infrared board spare part information
Description
Infrared board
Before removing the infrared board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. Fan (see
d. System board (see
Remove the infrared board:
1. Remove the Phillips M2.0×3.0 screw (1) that secures the infrared board to the keyboard/top cover.
2. Remove the infrared board (2) and cable.
Reverse this procedure to install the infrared board and cable.
64 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 33)
Solid-state drive on page
Fan on page 38)
System board on page
30), and then remove the following components:
35)
58)
Spare part number
L94506-001