EAS33363
REMOVING THE TAIL COVER
Refer to "GENERAL CHASSIS (1)" on page 4-1.
EAS33371
INSTALLING THE CCU (for YZF-R1M)
TIP
When the passenger seat cover is attached, the
total number of occupants is reduced to one per-
son. Depending on your area's regulations, it
may be necessary to change the vehicle's regis-
tration to reflect this. Contact your local authori-
ties.
EAS31676
CONNECTING TO THE CCU (for YZF-R1M)
The CCU (Communication Control Unit) con-
nects to the vehicle's CAN (Controller Area Net-
work) and has a GPS receiver to enable the
recording of vehicle and riding data. (Refer to
"MENU SCREEN" on page 1-6.) Logging data
and YRC setting data can be accessed when a
smartphone or tablet is connected to the CCU
wireless network.
TIP
From the Google© or Apple© application store,
download the "Y-TRAC" application to make use
of the logging data and the "YRC Setting" appli-
cation to remotely adjust the YRC settings.
1. Connect:
• CCU wireless network
a. Remove the bolts "1" and then remove the
passenger seat cover assembly "2" as
shown.
2
1
b. Note down the CCU serial number "a".
c. Turn the main switch to "ON" and ap-
proach the vehicle with a wireless capable
smartphone or tablet.
d. Connect to the wireless network "Yamaha
Motor Network" by inputting the CCU seri-
al number as the password.
TIP
Since all CCU-equipped models put out a simi-
larly named wireless network, have only one ve-
hicle turned on at a time to avoid confusion.
e. Install the passenger seat cover assembly
to the original position, and then install the
bolts.
EAS33364
INSTALLING THE TAIL COVER
Refer to "GENERAL CHASSIS (1)" on page 4-1.
1
4-8
GENERAL CHASSIS (2)
a
Passenger seat cover bolt (for
YZF-R1M)
7 N·m (0.7 kgf·m, 5.2 lb·ft)