Yamaha YZF-R1 Series Service Manual page 57

1. Handlebar switch lead (right)
2. Clutch cable
3. Handlebar switch lead (left)
4. Clutch switch connector
5. Main switch lead
6. Horn lead
Radiator bracket (left)
7.
8. Intake solenoid vacuum hose
9. Horn
10. Steering damper solenoid lead
11. Front brake hose
12. Front fork stepping motor sub-wire harness
A. Route the handlebar switch lead (right) to the rear
of the front brake hose. Be sure not to pinch the
handlebar switch lead (right) between the front fork
and the front brake hose.
B. Make sure that the horn lead and clutch switch
lead do not cross.
C. Make sure that the leads do not cross within the
range shown in the illustration.
D. Fasten the horn lead to the lower bracket with a
plastic locking tie. Position the plastic locking tie
between the outer tube and the steering lock
portion of the lower bracket. Face the buckle of the
plastic locking tie forward with the end pointing
upward, and then cut off the excess end of the tie
to 5 mm (0.2 in) or less.
E. To front wheel sensor
F. Route the clutch cable to the rear of the handlebar
switch lead (right).
G. Route the handlebar switch lead (right) to the front
of the main switch lead.
H. Route the horn lead to the front of the lower
bracket.
I. For YZF-R1M
J. Connect the front fork stepping motor coupler
(right), which is identified by the tape on the lead,
to the right front fork leg.
K. Route the front fork stepping motor sub-wire
harness to the rear of the clutch cable and
handlebar switch lead (left).
L. Insert the projection on the front fork stepping
motor sub-wire harness holder into the hole in the
cable guide from the bottom of the guide. Route
the front fork stepping motor sub-wire harness
under the clutch cable.
M. Connect the front fork stepping motor coupler (left/
right), and then slide the waterproof cover until it
contacts the front fork cap bolt (left/right).
N. Fasten the front fork stepping motor sub-wire
harness at the lower edge of the black tape to the
straight section of the brake fluid reservoir hose
with the holder. Face the catch of the holder
downward.
2-18
CABLE ROUTING