Yamaha YZF-R1 Series Service Manual page 330

TIP
While holding the generator rotor "2" with the
15mm pin type rotor holding tool "3", tighten the
generator rotor bolt.
15mm pin type rotor holding tool
90890-04171
YM-04171
3
3. Apply:
• Sealant
(onto the stator coil assembly lead grommet)
Yamaha bond No. 1215
90890-85505
(Three bond No.1215®)
G088980
4. Install:
• Generator cover gasket
• Generator cover
• Generator cover bolt
Generator cover bolt
1st: 6 N·m (0.6 kgf·m, 4.4 lb·ft)
*
2nd: 3.0 N
·
lb ft)
Specified angle 90°
*
Following the tightening order, loosen the
bolt one by one and then retighten it to the
specific torque and the specific angle.
2
1
New
New
· ·
m (0.30 kgf m, 2.2
TIP
Tighten the generator cover bolts in the tighten-
ing sequence as shown.
8
7
6
5
4
5. Connect:
• Stator coil coupler
• Crankshaft position sensor coupler
TIP
To route the stator coil lead, refer to "CABLE
ROUTING" on page 2-17.
5-47
GENERATOR
1
2
3