Data Plan - Huawei S Series Quick Configuration

Campus switches
Hide thumbs Also See for S Series:
Table of Contents

Advertisement

3.1

Data Plan

Before configuring the switches and router, prepare the following data for use in the next
section.
Action
Component
Management
interface IP
address
Configure the
management
IP address
Management
and Telnet
VLAN
Port type
Configure
interfaces
and VLANs
VLAN ID
DHCP server
Configure
Address pool
DHCP
Address
allocation
IP address
Configure
routing
Link aggregation
Data
10.10.1.1/24
VLAN 5
The Trunk port connects
to a switch, and the
Access port connects to
a PC.
ACC1: VLAN 10, 20
CORE1: VLAN 10, 20, 30,
40, 50, 100, 300
CORE1,CORE2
VLAN 10: IP address
pool 10
VLAN 20: IP address
pool 20
Based on a global
address pool
CORE1:
VLANIF 100
172.16.1.1/24
VLANIF 300
172.16.3.1/24
VLANIF 10
192.168.10.1/24
VLANIF 20
192.168.20.1/24
None
24
Description
The management IP address is used to log in
to the switch.
A modular switch's management interface is Ethernet0/0/0.
A fixed switch's management interface is MEth0/0/1.
For switches without management interfaces, you are
advised to use VLANIF interfaces for inband management.
This configuration is for Trunk and Access port
setup. If a Hybrid port setup is available on a
switch, this port can connect to either a host or
another switch.
VLAN1 is the default VLAN on the switch.
To isolate departments A and B at Layer 2, add A to
VLAN 10 and B to VLAN 20.
CORE1 connects to the egress router through
VLANIF100.
Configure the DHCP server on CORE1 and CORE2.
Terminals in department A obtain IP addresses
from IP address pool 10.
Terminals in department B obtain IP addresses
from IP address pool 20.
None
CORE1 connects to the campus egress router
through VLANIF 100 and connects to CORE2
through VLANIF 300.
Configure a primary route to CORE1 with the next
hop pointing to the egress router and a backup route
with the next hop pointing to CORE2.
After configuring the IP addresses of VLANIF 10 and
VLANIF 20 on CORE1, departments A and B can
then communicate through CORE1.
The link aggregation mode can be load balancing
or static LACP.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

S2750S5700

Table of Contents