Huawei S Series Quick Configuration page 11

3
Configure Telnet.
[HUAWEI] telnet server enable
[HUAWEI] user-interface vty 0 4
the switch through Telnet. AAA authentication is recommended.
[HUAWEI-ui-vty0-4] protocol inbound telnet
//V200R006 and earlier versions support Telnet. V200R007 and later versions
support SSH by default. If the switch runs V200R007 or a later version, run
this command before logging to the switch using Telnet.
[HUAWEI-ui-vty0-4] authentication-mode aaa
[HUAWEI-ui-vty0-4] idle-timeout 15
[HUAWEI-ui-vty0-4] quit
[HUAWEI] aaa
[HUAWEI-aaa] local-user admin password irreversible-cipher
//Configure the user name and password for Telnet login. The user name is
case-insensitive, whereas the password is case-sensitive.
[HUAWEI-aaa] local-user admin privilege level 15
account level to 15 (highest).
[HUAWEI-aaa] local-user admin service-type telnet
Use of STelnet V2 to log in to the switch is recommended because the
Telnet protocol has security risks. For this configuration procedure, see
the corresponding
the version of the device.
Log in to the switch from an operation terminal through Telnet. When the user view
4
prompt is displayed, you have successfully logged in.
C:\Documents and Settings\Administrator> telnet 10.10.1.1
management IP address and press Enter.
Login authentication
Username:admin
Password:
Info: The max number of VTY users is 5, and the number
of current VTY users on line is 1.
The current login time is 2014-05-06 18:33:18+00:00.
<HUAWEI>
//By default, the Telnet function is disabled.
//An administrator generally logs in to
Configuration Guide - Basic Configuration
//Enter the user name and password.
//User view prompt
//Set the administrator
8
Helloworld@6789
based on
//Enter the