Huawei S Series Quick Configuration page 63

Configuring the AC So That the AC and APs Can
Transmit CAPWAP Packets
1
Add GE0/0/1, GE0/0/2, and GE0/0/3 on Switch_A to VLAN 100 (management VLAN).
<HUAWEI> system-view
[HUAWEI] sysname Switch_A
[Switch_A] vlan batch 100
[Switch_A] interface gigabitethernet 0/0/1
[Switch_A-GigabitEthernet0/0/1] port link-type trunk
[Switch_A-GigabitEthernet0/0/1] port trunk pvid vlan 100
[Switch_A-GigabitEthernet0/0/1] port trunk allow-pass vlan 100
[Switch_A-GigabitEthernet0/0/1] port-isolate enable
[Switch_A-GigabitEthernet0/0/1] quit
[Switch_A] interface gigabitethernet 0/0/2
[Switch_A-GigabitEthernet0/0/2] port link-type trunk
[Switch_A-GigabitEthernet0/0/2] port trunk allow-pass vlan 100
[Switch_A-GigabitEthernet0/0/2] quit
[Switch_A] interface gigabitethernet 0/0/3
[Switch_A-GigabitEthernet0/0/3] port link-type trunk
[Switch_A-GigabitEthernet0/0/3] port trunk pvid vlan 100
[Switch_A-GigabitEthernet0/0/3] port trunk allow-pass vlan 100
[Switch_A-GigabitEthernet0/0/3] port-isolate enable
[Switch_A-GigabitEthernet0/0/3] quit
2
Add GE0/0/1 connecting the AC to Switch_A to VLAN 100.
<HUAWEI> system-view
[HUAWEI] sysname AC
[AC] vlan batch 100
[AC] interface gigabitethernet 0/0/1
[AC-GigabitEthernet0/0/1] port link-type trunk
[AC-GigabitEthernet0/0/1] port trunk allow-pass vlan 100
[AC-GigabitEthernet0/0/1] quit
In tunnel forwarding mode, APs encapsulate data packets over CAPWAP
data tunnels and send them to the AC, which then forwards these
packets to the upper-layer network. In tunnel forwarding mode, the
management VLAN and service VLAN cannot be the same. The network
between the AC and APs can permit packets only with management
VLAN tags to pass through, and does not permit packets with service
VLAN tags to pass through.
60