Huawei S Series Quick Configuration page 12

Configuring Interfaces and VLANs
a. Configure the access switch.
1
Starting with access switch ACC1 as an example, create service VLAN 10 on ACC1.
<HUAWEI> system-view
[HUAWEI] sysname ACC1
[ACC1] vlan batch 10
Configure Eth-Trunk 1, through which ACC1 connects to the CORE, to allow the
2
packets from the VLAN of department A to pass through.
[ACC1] interface eth-trunk 1
[ACC1-Eth-Trunk1] port link-type trunk
Trunk for VLAN transparent transmission.
[ACC1-Eth-Trunk1]
to transparently transmit the service VLAN on ACC1.
[ACC1-Eth-Trunk1] mode lacp
on Eth-Trunk 1.
[ACC1-Eth-Trunk1] quit
[ACC1] interface GigabitEthernet 0/0/1
Eth-Trunk 1.
[ACC1-GigabitEthernet0/0/1] Eth-Trunk 1
[ACC1-GigabitEthernet0/0/1] quit
[ACC1] interface GigabitEthernet 0/0/2
[ACC1-GigabitEthernet0/0/2] Eth-Trunk 1
[ACC1-GigabitEthernet0/0/2] quit
//Set the switch name to ACC1.
//Create VLANs in a batch.
port trunk allow-pass vlan 10
//Set Eth-Trunk 1 type to
//Configure Eth-Trunk 1
//Configure the LACP mode
//Add member interfaces to
9