Huawei S Series Quick Configuration page 10

3
Press Connect until the following information is displayed. Enter your new password,
and then re-enter it to confirm.
Login authentication
Username:admin
Password:
If you log in to the switch for the first time in versions earlier than
V200R010C00, the system asks you to set a login password. In
V200R010C00 and later versions, the default user name for first login is
admin and default password is admin@huawei.com. You must
change the password after login.
You can now run commands to configure the switch. Enter a question mark (?) after
a command whenever you need help.
Configuring the Management IP Address and Telnet
After configuring the management IP address of a switch, you can log in to the switch
using this address. CORE is used in the example below to show the procedure of
configuring the management IP address and Telnet.
1
Configure the management IP address.
<HUAWEI> system-view
[HUAWEI] vlan 5
[HUAWEI-VLAN5] management-vlan
[HUAWEI-VLAN5] quit
[HUAWEI] interface vlanif 5
[HUAWEI-vlanif5] ip address 10.10.1.1 24
[HUAWEI-vlanif5] quit
2 Add the management interface to the management VLAN.
[HUAWEI] interface GigabitEthernet 0/0/8
connected to the NMS is GigabitEthernet 0/0/8.
[HUAWEI-GigabitEthernet0/0/8] port link-type trunk
[HUAWEI-GigabitEthernet0/0/8] port trunk allow-pass vlan 5
[HUAWEI-GigabitEthernet0/0/8] quit
//Create management VLAN 5.
//Assume that the interface
7