Axis 2N LiftIP User Manual page 89

Caution
Make sure that the command line is started by admin. If it is started by a
user, the editor authenticating window will pop up.
Note
®
The 2N
space at least.
®
Now the 2N LiftIP
desktop (see the figure below) or select the Start item to start the application.
After the application launch, the splashscreen gets displayed to inform you of the
application manufacturer and current version. After the launch, you will see the basic
screen and Configuration / Parameters
be prepared for you to export the data. Click
CU and move to the
you enter the IP address if available. At the same time, set the communication port if
changed and enter the valid password. Click Connect to get connected to
®
2N LiftIP and read the configuration. Select Remember password to save the
2N TELEKOMUNIKACE a.s., www.2n.cz
Application Installation Command
LiftIP Service Tool
Service Tool is ready for use. Click the shortcut item on the
®
Icon of 2N
menu. Here an offline table of parameters can
Connect to device menu. A login window will be displayed where
installation requires
LiftIP Service Tool
Connect device
500 MB of free disk
to get connected to the
89/117