Axis 2N LiftIP User Manual page 46

Warning
Disconnect LiftIP from the power supply while connecting the IO
extender (DC 10–30 V or PoE).
Make sure that all the pins are inserted in the connector correctly while
connecting the IO extender.
Keep the correct connector wiring (yellow wire - see the figure below).
Wrong wiring may lead to a module damage.
Technical Parameters
Input
Input type contact controlled, galvanically non-isolated
Warning
Never connect any voltage sources to the input. You can only connect
the N/O contact that is not connected to any other circuit.
Outputs
Maximum load
2N TELEKOMUNIKACE a.s., www.2n.cz
60 V / 500 mA
46/117