Axis 2N LiftIP User Manual page 45

Warning
Disconnect LiftIP from the power supply while connecting the IO
extender (DC 10–30 V or PoE).
Make sure that all the pins are inserted in the 6-pin connector correctly
while connecting the IO extender.
Keep the correct connector wiring (yellow wire - see the figure below).
Wrong wiring may lead to a module damage.
Put the IO module in the attached insulation tube and tighten with cable
ties before installation to protect the circuits against short-circuit with
other conductive objects!
Connection via Voice Alarm Station
You can also connect the IO extender via a Voice Alarm Station (VAS). Insert the VAS
in the Extender connector (refer to Subs. 2.7 of the VAS manual).
Connect the IO extender to the VAS switch. Put the connector on the Alarm IN
/Program jumper (see the figure below).
2N TELEKOMUNIKACE a.s., www.2n.cz 45/117