Keysight N9340B Demo Manual page 30

Section 14
Automation
Communications systems require routine spectrum monitoring to keep them
working reliably long term. Routine spectrum monitoring is usually automated
with software that controls the spectrum analyzer remotely. You can program
and control the N9340B using SCPI programming over LAN or USB and monitor
signal changes remotely.
The following two modes are used to set up the N9340B's LAN IP address:
– Static
– DHCP
For the following demos, the N9340B's PC software and the Keysight I/O library
should be installed on your PC.
Remote control the N9340B via USB.
Instruction
Connect the N9340B and PC with a
USB cable.
Run the Keysight N9340 PC software on
the PC.
Monitor the signal on the PC.
You can set up the corresponding N9340B's
parameters using a mouse.
30
Key strokes
Click the N9340 PC software shortcut
key on the PC screen.
Click the Monitor shortcut key.
Highlight the corresponding USB
address of the N9340B in the instrument
list dialog box.
Click ENTER.
Example:
Changing the center frequency:
Move the cursor to the center and double
click.
Input the center frequency; select the
unit and click Set in the center frequency
dialog box.