Keysight N9340B Demo Manual page 22

Section 11
Field Strength Measurements (continued)
Figure 14. Field strength measurement
2. Load the antenna file into the N9340B via a USB
memory stick.
Instruction
Create an N9340DATA folder in the root
directory of the USB memory stick.
Copy the antenna file from PC to the
N9340DATA folder. Insert this USB memory
stick into the N9340B USB port.
Turn on the field strength measurement
function.
Load the antenna file into N9340B via USB.
3. Run the field strength measurement function.
Instruction
Connect the antenna to the RF IN connector.
Turn on the field strength function.
Load the antenna file.
You can set up limit lines using the N9340B limit function or the PC software.
The N9340B fi eld strength measurements are automatically adjusted using the
antenna factors defined in the antenna table of the N9340B PC software.
22
Key strokes
[MEAS], {FiledStrengh}, {More}, {Field
Strength}
[SYS], {File}, {View {Usb}}, {File Setup},
{File Type}, {Antenna}, rotate the knob to
highlight the file, {Copy}
Key strokes
[MEAS], {More}, {FieldStrength}
{AntennaTable}, highlight the file by
rotating the knob, {Load}