Nice WIDE M Installer's Instructions page 17

From Standby status
Action
To enter the program menu.
Press and hold the  button
until buzzer beeps.
Scroll < or > to select the
runtime setup option.
With "Overload Setting" on
the display, press and release
.
Scroll < or > to the required
setting.
With required setting
displayed, press and release
.
After display confirms new
setting.
Scroll left or right to next
program option.
From Standby status
Action
To enter the program menu.
Press and hold the  button
until buzzer beeps.
Scroll < or > to select the
beam setup option.
With "Beam Setup" on the
display, press and release .
Scroll < or > to toggle
between "Enabled" and
"Disabled".
With required setting
displayed, press and release
.
After display confirms new
setting.
Scroll left or right to next
program option.
Selecting a safety level.
- "Selected" mode -
- Standby
Description
Display and buzzer
confirms.
Display scrolls
through options.
Display shows current
option status.
Display changes
respectively.
Display briefly shows
the new setting is
saved.
Display returns to
Overload Setting
programming menu
<  = change >
options list.
Safety infra-red beams setup.
- "Selected" mode -
- Standby
Description
Display and buzzer
confirms.
Display scrolls
through options.
Display shows current
option status.
Display changes
respectively.
Display briefly shows
the new setting is
saved.
Display returns to
Beam Setup
programming menu
Enabled Saved
options list.
This adjusts the force level, over and above the nominal
barrier resistance, needed to trigger the safety overload
routines. Level 1 being the most sensitive and 8 being the
least sensitive. The factory default is level 3.
Display
Programming menu
<or> for options
Overload Setting
<  = change >
Overload Setting
<
Overload Setting
<
Overload Setting
Saved = 2
Overload Setting
<  = change >
EXIT back to standby
OR
status
Use this option to enable the safety beam circuit for use in
standard BT mode. (See page 20)
Display
Programming menu
<or> for options
Beam Setup
<  = change >
Beam Setup
Disabled
Beam Setup
Enabled
Beam Setup
Enabled Saved
Beam Setup
<  = change >
EXIT back to standby
OR
status
17
Overload Setting
Response
Buzzer
x2
x1
>
x1
>
x2
Beam Setup.
Response
Buzzer
x2
x1
x1
x2
Barrier
"Selected" mode
- Standby
Barrier
"Selected" mode
- Standby