Nice WIDE M Installer's Instructions page 15

The control unit is equipped with a LCD display and interactive keys for simplified programming and diagnostics. All setup, of the various features,
requires that the control card dashboard be used. Below are the functions of each key on the dashboard.
Navigate backward in menus, decrease
values, indicate lefthand closing barrier
in runtime setup function or enter
diagnostics menu while in standby.
Radio activity indicator.
Exit menu levels without saving.
1. Runtime setup. - Page 18.
2. Collision force sensing. Safety level setup. - Page 19.
3. Safety beam setup. - Page 19.
4. BT triggers operating mode selection and setup. - Page 20.
5. Receiver setup.
a. Learn remotes. - Pages 22, 23 and 24.
b. Erase remotes. - Pages 25 and 26.
c. Diagnose remotes. - Page 27.
d. Receiver information. - Page 28.
6. Advanced menu. - Pages 29 and 30.
a. Barrier speed
b. Soft stop speed.
c. Auxiliary relay setup.
d. Blue-bus setup.
e. Power settings.
f. Controller setup.
g. Controller information.
h. IEC Standards mode. Enable/disable. (Safety beams must be installed and configured before you can enable this mode)
i. Reset and restore.
Using the control card display and dashboard.
RF
Enter programming, advance to next
level of option on display, save value
Control card programming and setup.
Programming menu quick reference guide:
ACT
on display.
15
Navigate forward in menus, increase
values, indicate righthand closing
barrier in runtime setup function or
enter diagnostics menu while in standby.
Processor activity indicator.
Test BT mode when in standby or exit
all the way back to standby without
saving when in programming.