Nice WIDE M Installer's Instructions page 18

BT Mode Setting
From Standby status
Action
To enter the program menu.
Press and hold the  button
until buzzer beeps.
Scroll < or > to select the
beam setup option.
With "BT Mode Setting"
on the display, press and
release .
Scroll < or > to the required
BT mode option.
With required setting
displayed, press and release
.
Scroll < or > to the required
setting.
With required setting
displayed, press and release
.
If Complex was selected,
scroll < or > to the required
quick close time.
With required setting
displayed, press and release
.
After display confirms new
setting.
Scroll left or right to next
program option.
Selecting a BT operating mode and adjusting the BT auto-close time.
- "Selected" mode -
Description
Display and buzzer
confirms.
Display scrolls
through options.
Display shows current
option status.
Display changes
respectively.
If Simplex mode was
selected, the display
and buzzer will
confirm the setting
is saved. Display
then reverts to
programming options
list.
If Simplex Auto
or Complex were
selected, then the
buzzer beeps once,
and the display
prompts you to select
the required auto-
close time.
Display changes
respectively.
Display briefly shows
the new setting is
saved.
Display changes
respectively.
Display briefly shows
the new setting is
saved.
Display returns to
programming menu
options list.
The factory default is Simplex mode.
The factory default auto-close time is 20 seconds. The timer range
is 1 – 254 seconds. PLEASE NOTE!! To select any of the automatic
closing timers, a set of safety infra-red beams must be installed using
- Standby
the technique indicated in this manual to allow for barrier closing.
Failure to install and setup the safety beams first, will lock you out of
the Auto-close modes. The safety beam function on this control card
conforms to the CE safety standards.
Display
Programming menu
<or> for options
BT Mode Setting
<  = change >
BT Mode Setting
< Simplex
BT Mode Setting
< Simplex
BT Mode Setting
< Simplex Auto >
BT Mode Setting
< Complex
BT Mode Setting
Standard - Saved
Set Auto-close
time = 15s
Set Auto-close
time = 20s
Set Auto-close
Saved = 20s
Set Quick-close
time = 2s
Set Quick-close
Saved = 2s
BT Mode Setting
<  = change >
EXIT back to standby
OR
status
18
Response
Buzzer
x2
x1
>
>
x1
>
x2
x1
x2
Barrier
"Selected" mode
- Standby