Advertisement
Quick Links
StrongArmPark DC Articulating Arm
Review the illustrations for the steps involved in assembling the
articulating arm and attaching it to the StrongArmPark DC chassis.
Tools required
• Box end wrenches: 7/16 and 9/16 inch
• Socket head wrenches: 7/16 and 9/16 inch
• 1/4 - inch Hex key
Tip of the arm
Arm cap
Arm light cables inside arm's
articulating bracket
For detailed views of the assembly, see page 2.
www.hysecurity.com
© 2017
• Drill
• Drill bit 9/32 inch
Drill 9/32 inch
mounting holes
1/4 inch
fasteners
Connect arm
light cables.
Tuck wiring
inside arm.
Page 1
Installation Instructions
Breakaway bracket and
Mounting bracket assembly
described in StrongArmPark DC
Quick Start Steps, MX3651-01.
Rod end
If the tip of the arm droops or angles up too much, level
the arm by tightening or loosen the linkage fasteners
that secure the rod ends.
MX3114
Rod end
P/N MX3114 D0584 Rev E
Advertisement
Related Manuals for Nice HySecurity StrongArmPark DC Series
Summary of Contents for Nice HySecurity StrongArmPark DC Series
- Page 1 Installation Instructions MX3114 StrongArmPark DC Articulating Arm Review the illustrations for the steps involved in assembling the articulating arm and attaching it to the StrongArmPark DC chassis. Breakaway bracket and Mounting bracket assembly Tools required described in StrongArmPark DC Quick Start Steps, MX3651-01. •...
- Page 2 StrongArmPark DC: Articulating Arm Assembly Follow the steps and secure the fasteners as shown. Technical Support For technical support, call your installer or authorized HySecurity distributor. Obtain the serial number of your operator before calling. Arm lights connection For the name of a distributor near you, call HySecurity at 800-321-9947. Arm lights connection 1/4 inch...
- Page 3 StrongArmPark DC: Lighting Connection for Articulated Arm 1. Make sure both AC and DC power switches are turned OFF. DC Power Switch 2. Insert leads of wire harness through the hole in chassis between the two bracket mounts. Feed the cable through the interior of the chassis.
- Page 4 5. Connect the one wire lead to the 24VDC power supply terminal. See wiring illustrations on page 2. 6. Connect the other wire lead to the NO terminal on User Relay 2. 7. Turn on both AC and DC power switches. Arm will cycle to search for the target home position.