Nice WIDE M Installer's Instructions page 24

Receiver programming and setup.
From Standby status
Action
To enter the program
menu. Press and hold the
 button until buzzer
beeps.
Scroll < or > to select the
receiver setup option.
With "Receiver Setup"
on the display, press and
release .
Scroll < or > to select the
Diagnose Remotes option.
With "Diagnose Remotes"
on the display, press and
release .
After prompt.
Press and release remote
that you are testing.
Multiple remote buttons can be tested by repeating the last step above here.
Press and hold the X button
when finished testing.
Release X button.
Scroll left or right to next
program option.
Diagnose remotes.
- "Selected" mode -
- Standby
Description
Display and buzzer
confirms.
Display scrolls
through options.
Display shows current
option status.
Display scrolls
through options.
Display prompts you
to press and release a
remote button.
Display shows a signal
strength graph and
waits for a remote
transmission.
If the remote button
is in the memory the
display will confirm
the signal strength,
user address and
function of that
button. The higher
the graph goes, the
stronger the signal.
If the remote button
is not in the memory
the display will
confirm the signal
strength and confirm
the remote is not
recognised.The higher
the graph goes, the
stronger the signal.
Display Diagnose
Remotes optionhas
been exited and
buzzer beeps.
Display reverts to
Receiver Setup
options.
OR
The barrier can be in any position when performing this routine.
This feature can be used to determine if there is 433.92MHz radio
interference. Use this feature to check previously learnt remotes.
Response
Display
Programming menu
<or> for options
Receiver Setup
<  = change >
Receiver Setup
Quick learn
Receiver Setup
Diagnose Remotes
Diagnose Remotes
Press Remote
Signal:
Not recognised
Signal:
Adr: 1 Func: BT
Signal:
Not recognised
Diagnose Remote
Exited
Receiver Setup
Diagnose Remote
EXIT back to standby
status
24
Receiver Setup
Buzzer Barrier
x2
x1
x1
"Selected" mode
- Standby