Table of Contents
Advertisement
Page 3
Be Safe! Instructions, warnings and obligations.
Page 4
Technical specifications.
Page 5
Component identification and descriptions.
Page 6
Pole lengths (limitations) and pole accessory kits.
Page 7
Calculating the duty cycle.
Page 7
Positioning the barrier.
Page 8
Typical cabling requirements.
Page 9
Baseplate kit and installing the baseplate.
Page 10 Opening the cabinet.
Page 10 Mounting onto the baseplate.
Page 11 How to use the manual override.
Page 11 Changing the handedness of the barrier.
Page 12 Attaching the boom pole mounting to the output shaft.
Page 13 Checking and adjusting the spring balancing.
Page 14 Terminating the AC supply.
Page 15 Wiring and termination of the control card.
Page 16 Adjusting the slow down switches.
Page 17 Programming menu quick reference guide.
Page 18 Setting up the barrier runtime.
Page 19 Selecting a safety level.
Page 19 Safety infra-red beams setup.
Page 20 Selecting a BT operating mode and adjusting the BT auto-close time.
Page 22 Receiver programming and setup.
Page 29 Advance programming options and their definitions.
Page 31 Collision sensing and safety overload routines
Page 32 "BM" Safety infra-red beams function.
Page 33 "BT" Button triggers - Simplexmode.
Page 34 "BT" Button triggers - Simplex auto-close mode.
Page 35 "BT" Button triggers - Complex auto-close mode.
Page 36 "OPEN" Open only triggers.
Page 37 "E-STOP" Emergency stop triggers.
Page 38 Auxiliary relay modes - Strike lock mode.
Page 39 Auxiliary relay modes - Magnetic lock mode.
Page 40 Auxiliary relay modes - Courtesy light mode.
Page 41 Auxiliary relay modes - Receiver relay mode.
Page 42 Auxiliary relay modes - Traffic light mode.
Page 43 Holiday lock-out mode.
Page 44 Auto-close override/party mode.
Page 45 Tamper alarms.
Page 48 Status LED, buzzer and diagnostics menu definitions.
Page 50 Troubleshooting guide and display definitions.
Page 53 Warranty.
For any assistance with this product that is not covered in this manual please contact us on: 0860 109 238 (RSA) or via our online
support facility at www.etnice.co.za.
Introduction.
Site preparation.
Hardware installation - Mechanical.
Hardware installation - Electrical.
Control card programming and setup.
Operating mode definitions and examples.
Troubleshooting.
2
Hide quick links:
Advertisement
Table of Contents
