Receiver Setup - Nice WIDE M Installer's Instructions

Receiver Setup

From Standby status
Action
To enter the program
menu. Press and hold the
 button until buzzer
beeps.
Scroll < or > to select the
receiver setup option.
With "Receiver Setup"
on the display, press and
release .
With "Quick learn" on the
display, press and release
.
Scroll < or > to the required
receiver function/channel
option.
NB! Corresponding 4
function learn option
is explained in the next
instruction table on the
next page.
Press and hold required
button on the remote
transmitter.
While still transmitting with
the remote button, press
and release .
Release the button on the
remote transmitter.
Repeat the last 4 steps here for additional users or functions, or exit back one level in the receiver setup menu for other receiver setup options.
Scroll left or right to next
program option.
Receiver programming and setup.
Setting up a new user: - Quick learn method.
The barrier can be in any position when performing this routine.
- "Selected" mode -
Please note that if an ET BLU MIX © transmitter is being used and
- Standby
not all of the buttons have been set to the same format, then the
receiver will allocate 2 user addresses for the various buttons. 1 for
the buttons set to ET BLU MIX© and 1 for the buttons set to ET BLUE.
Description
Programming menu
Display and buzzer
confirms.
<or> for options
Receiver Setup
Display scrolls
through options.
<
Receiver Setup
Display shows current
option status.
Quick learn
Display prompts you Select function
to select a function. BT, Full opening
Select function
BT, Full opening
Select function
Pedestrian opening
Select function
Display changes
respectively. Auxiliary relay
Select function
Holiday lockout
Select function
Corresponding
After the  button
has been released,
the user address
for that transmitter
displays and the
buzzer beeps once.
OR
19
Response
Display Buzzer
 = change >
EXIT back to standby
status
Barrier
x2
x1
x1
x1
"Selected" mode
- Standby