Hdbaset Receiver - Bolin Technology VCC-8-4K20S-3SMB User Manual

HDBaseT Receiver

18. LAN Port (RJ45, IP Pass-Thru)
Connect network switch or router to this port for Dual Output HDMI+IP HDBaseT camera.
NOTE:

This HDBaseT receiver is not an IP video encoder. The LAN Port is the IP video extension for the IP
video output on the camera side. Do not use it as an IP video encoder.

It is not for use with model VCC-8-4K20S-3SMB.
19. IR Remote Controller Indicator
These are sensors to receive commands from infrared remote controller, distance up to 10 meters.
You can use IR remote controller to control the camera from the remote side via HDBaseT receiver.
20. RS-422 Control Port
Use RJ45 to RS-422 extension adapter cable to remotely control PTZ camera. (Extension cable detail view on
page 15)
21. RS232 Control Port
Use RJ45 to RS-232 extension adapter cable to remotely control PTZ camera (Extension cable detail view on
page 15)
22. 12V DC Power Port
Connect include 12V DC power adaptor and cord.
23. Power LED Indicator
Turns red when the device is connected to power outlet.
24. Heat-sink surface panel
All aluminum body for quick heat dissipation.
25. HDMI Upholder
For tightening up HDMI port in stabilization.
26. 3.5mm IR IN
Connect to an IR receiver, The IR signal received from this port can send out via HDBaseT receiver.
27. v1.4b HDMI Video Output
Connect to HDMI source display.
28. RJ45 Port for HDBaseT Input (POH)
Support One-Cable transmission of camera power (POH), 4K video and control signal. Connects to the
HDBaseT camera via CAT5e/CAT6 cable. (Transmission distances of up to 100M/328ft)
29. 3.5mm jack Audio Out
30. HDBaseT Port Signal Link indicator
The LED lit GREEN when the camera is powered on.
31. HDBaseT Port Signal Link indicator
The LED flashes ORANGE when the camera transmits data with HDBaseT.
8