Procedure To Backfeed The Media To The Print Position After Cutting - Oki IP-6620 User Manual

Procedure to backfeed the media to the print position after cutting

1
PRINTER READY
01: PAPER/1626mm
2
BACKFEEDING MEDIA...
STOP AT PRINT POS
3
BACKFEEDING MEDIA...
(Automatic backfeeding ends or is canceled.)
4
PRINTER READY
01: PAPER/1626mm
Notes
‹ After backfeeding the media, wind the media manually to remove the slack before performing the next print job.
‹ The automatic backfeeding function is disabled in the following cases.
- No media is installed.
- No printing has been performed after installing the media.
- The end of the printout is located after the print position.
78
Loading the media
>
+
Press the Up button.
After the operation panel display has
changed to the screen shown on the left,
keep the Up button pressed and press Right
button.
After the operation panel display has
changed to the screen shown on the left,
release both the Up and Right buttons.
The media is backfed automatically to the print position
even if you release the buttons.
š Press the OK button or the CANCEL button to
cancel automatic backfeeding of the media.
š Even after canceling automatic backfeeding of
the media, you can perform steps
automatically backfeed the media to print position.
š Use the Down and Up buttons if you want to fine
adjust the printing position.
1 2
and again to