Move The Printer - Oki IP-6620 User Manual

Move the printer

If you wish to move the printer several meters on the same site, across a horizontal floor with no steps and no slopes,
see the following instructions.
For more difficult movement, contact your dealer or a service representative.
CAUTION
‹ Do not move the printer with a media roll attached. Otherwise the heavy media may damage the printer.
‹ Raise a little the leveling feet (two on the front and two on the rear) of the printer before moving the printer. Do not forget
to set these leveling feet again after moving the printer to secure it.
‹ Move the printer carefully so that the leveling feet do not hit any obstructions.
‹ Make sure that the TUR unit casters do not reach the floor when moving the printer.
‹ If the casters touch the floor, remove the screws shown circled in the figure below and remove the casters. One caster is
equipped at both the right and left sides of the TUR unit. Moving the printer without removing them may damage the TUR
unit casters.
Printer's caster
TUR unit's caster
Adjustable leveling feet
Remove the screws to remove the caster.
Advanced operations
227