Oki IP-6620 User Manual page 123

7
8
Required items
1. Dropper
Note
‹ The items 1, 2, and 3 above are included in the sheet mount cleaning kit A (IP6-261).
‹ Do not discard the items 1 and 2 above after use, but use them again for sheet mount cleaning.
8-a
Raise the wiper cleaning liquid bottle a little
and pull out the bottle after making sure that
all the liquid has flowed into the printer.
Lift the wiper sponge little by little while
pulling it toward you. After confirming that
the liquid in the wiper sponge has completely
flowed in the printer, remove the wiper
sponge.
2. Sheet mount cleaning liquid
Draw 1 ml of sheet mount cleaning liquid
using the dropper.
1 ml gradation
Note
‹ Visually check that the waste ink bottle is not full before
removing it.
To check the numbers of the nozzles
with nozzle map
š If you can remove the wiper sponge from the wiper
unit, remove it and then go to step
š If the wiper sponge adheres because ink has dried
and you cannot remove it, perform the following
8-a 8-b 8-c
steps , , , and
step 9.
3. Gloves
9
.
8-d
before you continue to
Maintenance
123