Oki IP-6620 User Manual page 52

12
13
Place the media so that the pressure roller
evenly touches the media.
š Note the position of the media edges on the sticker gradations to facilitate position adjustment the next time you
Note
‹ Always move the media holders to adjust the position. Moving only the media may cause it to skew.
52
Loading the media
load the media.
Adjust the media position so that the
edge is place above the gradations.
Pass the media between the pressure roller
and the grit roller. When you hear a beep
sound, feed the media 80 cm further.
The printer emits a sound when the media leading edge
comes out from the front cover.
Notes
‹ Depending on the environment, the media may stick to
the paper guide and have difficulty to advance. In such
a case, hold both ends of the roll to separate the media
from the paper guide and then feed the media.
‹ If the leading edge of the media curls up or down, it may
get caught inside the printer and may not be installed
properly. Do not use heavily curled media.
‹ Make sure that the leading edge of the media does
not touch the front cover. If the media forms a curve,
straighten it before the installation.
‹ Check that the media edge guards are not caught under
the media.
Move the media holders so that the media
edges are evenly placed under the pressure
roller.