Sensor Settings - Seametrics LevelSCOUT Instructions Manual

SETTINGS AND CALIBRATION
LEVELSCOUT INSTR

Sensor Settings

Once connected you'll see the Sensor screen appear and display the connected sensor(s)
details. Mousing over icons will provide tool-tips, mouse over to view sensor firmware
and serial number details.
To change general sensor settings click in the sensor screen. This allows you to
change the following:
Click to rename the sensor
To change Modbus address and/or Baud Rate simply select the desired address and/or
Baud Rate from the drop down menus. Sensor will automatically reconnect at new address
and/or Baud Rate
To change the Direct Read output units (for direct Modbus or SDI12 integration) simply
select the desired output units from the drop down menus. To change Aqua4Plus 2.0
display units scaling see Program Settings.
Sensor Clock can be synced with your PC time or set manually if desired. To set manually
enter your desired date/time and click Set Time.
When batteries are changed out make sure to reset the battery information here, simply
check the I have just put in new batteries box and select the battery type that was installed
from the drop down menu.
Seametrics • 253.872.0284 Page 12 seametrics.com