Direct Read Modbus/Sdi-12; Settings Units For Direct Read - Seametrics LevelSCOUT Instructions Manual

DIRECT READ MODBUS/SDI - 12
While the LevelSCOUT comes with Seametrics's easy to use Aqua4Plus 2.0 software, you
can also use standard Modbus
your existing equipment or networks.
Setting Units for Direct Read
By default, the LevelSCOUT uses the following units:
Temperature
Level
However, you can select from a variety of units for direct read measurements. If you want
to change to different units, for example, degrees Fahrenheit for temperature or feet of
water for level, set these units using Aqua4Plus 2.0 (see sensor settings).
Once set, these units are saved on the sensor and direct readings will return values using
these units. (Note: These settings do not affect the units used on the Aqua4Plus 2.0 display.
Refer to the software manual for details.)
Seametrics • 253.872.0284
RTU equipment to easily take readings, so as to tie into
®
Degrees Celsius
PSI
Page 30
LEVELSCOUT INSTR
seametrics.com