Table of Contents
Advertisement
SETTINGS AND CALIBRATION
LEVELSCOUT INSTR
Under the Communications tab you can change your Modbus communication settings.
Typically you will only need to change the address range to connect to sensors outside
of Modbus address 1-10. In certain cases we may need to change the Retry and Timeout
settings to overcome communication issues on very long, or corroded cabling. See
Troubleshooting section or contact Seametrics Tech Support for details.
To restore factory default settings click
Seametrics • 253.872.0284
Page 14
seametrics.com
Advertisement
Table of Contents
Need help?
Do you have a question about the LevelSCOUT and is the answer not in the manual?
Questions and answers