Seametrics LevelSCOUT Instructions Manual page 21

OPERATION
Click to switch between interval and
continuous data recording (PT2X & CT2X
only) Select your continuous rate from the
drop down box (on the right).
Duration can be set by either number of
records or by setting a duration time, as
shown on the right.
When set by number of records the time of the recording phase will be displayed detailing
how long that phase will run. When set by time, the total number of records for that phase
will be displayed.
If you need to check settings or perform a calibration click
logging setup to switch to the Settings and Calibration screen.
You may sync the sensor clock with the PC
clock when starting logging by clicking the
slider shown on the right.
Check the Delayed Start box and enter the
desired date/time you would like logging
to start. This is useful for syncing data when
setting up multiple sensors on a site. Data will
start logging at the set date/time rather than
immediately when Start is pressed.
Data file name defaults to Test File # and may
be re-named here, like on the right.
Seametrics • 253.872.0284 Page 21
LEVELSCOUT INSTR
before proceeding with
seametrics.com