Set Bacnet Access - ADF Web HD67937-IP-B2 User Manual

Industrial Electronic Devices

SET BACNET ACCESS:

By Pressing the "Set BACnet Access
5). The window is divided in two parts, the
slaves and "BACnet Write" that contains the BACnet objects that the converter writes into the BACnet slaves.
Figure 5a: "Set BACnet Access
The means of the fields in the window (BACnet in Read) are the following:
In the field "IP Address /
In the field "Object Type" the object to be read is defined;
In the field "Instance" the instance number of the object is defined;
In the field "Property" the property to be read is defined;
In the field "NByte" the number of bytes of the BACnet object is defined;
By checking the field "En
Address (D Adr). These informations are used for make a request to other segments of network (through a BACnet router);
In the field "D Net" the destination network (from 1 to 65535) is defined;
In the field "D Len" the length of "D Add" field (1 or 2 or 6) is defined;
In the field "D Add" the address of the endpoint is defined. If "D Len" is '1' it is possible to insert a number from 1 to 255; if "D Len"
is '2' it is possible to insert a number from 1 to 65535; if "D Len" is '6' it is possible to insert an IP and port in this format
"192.168.2.188:47808";
In the field "Poll Time" the frequency of the request is defined (in ms);
ADFweb.com S.r.l.
" button from the main window of SW67937 (Fig. 2), the window "Set BACnet Access" appears (Fig.
"BACnet Read" that contains the BACnet objects that the converter reads from the BACnet
 BACnet Read" window
ID" the IP address / ID of the slave that contains the data to be read is defined;
Dest" it is possible to enable the Destination Network (D Net), Destination Length (D Len) and Destination
User Manual BACnet Master / MQTT
Document code: MN67937_ENG Revision 1.000 Page 26 of 36