112
6.6.2
Custom Timing
In LightField, Custom Timing is accessed via the Custom Sensor button on the Sensor
expander. In the Custom Timing panel, you can select from among the listed vertical
shift rate choices (see
row into the serial register. The smaller the value, the faster charge will be shifted up
one row at a time toward the serial register.
Figure 6-24: Typical LightField Custom Timing Pane
In WinX/32, the equivalent function is located on the Camera/Controller tab on the
Hardware Setup dialog. See
ProEM System Manual
NOTE:
This mode is standard with LightField for a ProEM full frame
EMCCD camera such as the ProEM:1600
Figure
6-24). Vertical shift rate is the time required to shift one
Figure
6-25.
(2)
.
Issue 3