Software Settings; Figure 6-22: Typical Winx/32 Hardware Setup: Custom Chip Tab - Teledyne ProEM Series System Manual

110
6.6.1.1

Software Settings

In WinX/32, if Custom Chip has been installed, selecting Show Custom Chip check box
on the Controller/Camera tab adds the Custom Chip tab to the Hardware Setup dialog.
The Custom Chip parameters are shown in
the physical layout of the CCD array and are optimum for most measurements.

Figure 6-22: Typical WinX/32 Hardware Setup: Custom Chip Tab

ProEM System Manual
!
CAUTION!
Teledyne Princeton Instruments does not encourage users
to change these parameter settings. For most applications,
the default settings will give the best results. We strongly
advise contacting the factory for guidance before
customizing the chip definition.
Figure 6-22. The default values conform to
Issue 3