Table of Contents
Advertisement
Filling Powder chemicals by HARDI FILLER
Grip positions used:
1. Fill the main tank at least 1/2 with water (unless something else is
stated on the chemical container label). See section "Filling of water".
2. Turn the handle at the Suction Manifold towards "Main tank" and
agitation valve towards "Agitation". Turn the green handle at the
Pressure Manifold towards "HARDI FILLER". Close remaining valves.
3. Engage the pump and increase P.T.O. speed to 540 r/min or 1000
r/min (depending on pump model).
4. Open the bottom valve (A) at the FILLER. Open FILLER lid.
5. Engage the hopper rinsing device by opening valve (C).
6. Measure the correct quantity of chemical and sprinkle it into the
hopper as fast as the rinsing device can flush it down.
7. If the chemical container is empty it can be rinsed by the contai-
ner rinsing device (if fitted). Fit the bag bracket and place the pow-
der bag over the multi-hole nozzle and press the lever (B).
8. Close valve (C) again when the hopper is rinsed.
9. Close valve (A) and the FILLER lid again.
10. When the spray liquid is well mixed, turn handle on the Pressure
Manifold towards "Spraying" position. Keep P.T.O. engaged so the
spray liquid is continuously agitated until it has been sprayed on the
crop.
DANGER! Do not press lever unless the multi-hole nozzle is covered by a container to avoid spray liquid hitting the
operator.
ATTENTION! Rinsing device uses spray liquid to rinse containers for concentrated chemicals. Always rinse the che-
mical containers with clean water several times until they are clean before disposal.
ATTENTION! The hopper rinsing device is using spray liquid for rinsing the hopper for concentrated chemical! The
FILLER must always be cleaned together with the rest of the sprayer when the spray job is done.
ATTENTION! The scale in the hopper can only be used if the sprayer is parked at level ground! It is recommended
to use a measuring jug for best accuracy.
5 - Operation
5.11
Advertisement
Table of Contents
