Table of Contents
Advertisement
5 - Operation
Filling Liquid chemicals by HARDI FILLER
Grip positions used:
1. Fill the main tank at least 1/3 with water (unless something else is
stated on the chemical container label). See section "Filling of water".
2. Turn the handle at the suction Manifold towards "Main tank". Turn
agitation valve towards "Agitation" and turn pressure Manifold
towards "HARDI FILLER". Close remaining valves.
3. Check that bottom valve (A) at the FILLER is closed.
4. Engage the pump and set P.T.O. speed at 540 r/min or 1000 r/min
(depending on pump model).
5. Open FILLER lid.
6. Measure the correct quantity of chemical and fill it into the hop-
per.
7. Open the bottom valve (A) and the chemical is transferred to the
main tank.
8. If the chemical container is empty it can be rinsed by the contai-
ner rinsing device (if fitted). Place the container over the multi-hole
nozzle and press the lever (B).
9. Engage the hopper rinsing device by opening valve (C).
10. Close valve (C) again when the hopper is rinsed.
11. Close valve (A) and the FILLER lid again.
12. When the spray liquid is well mixed, turn handle on the Pressure
Manifold towards "Spraying" position. Keep P.T.O. engaged so the
spray liquid is continuously agitated until it has been sprayed on the
crop.
ATTENTION! The scale in the hopper can only be used if the sprayer is parked at level ground! It is recommended
to use a measuring jug for best accuracy.
DANGER! Do not press lever unless the multi-hole nozzle is covered by a container to avoid spray liquid hitting the
operator.
ATTENTION! Rinsing device uses spray liquid to rinse containers for concentrated chemicals. Always rinse the che-
mical containers with clean water several times until they are clean before disposal.
ATTENTION! The hopper rinsing device is using spray liquid for rinsing the hopper for concentrated chemical! The
FILLER must always be cleaned together with the rest of the sprayer when the spray job is done.
5.10
Advertisement
Table of Contents
