Filling Liquid Chemicals By Hardi Turbofiller (Optional) - Hardi NEPTUN Series Instruction Book

Filling liquid chemicals by HARDI TurboFiller (optional)

1. Fill the main tank at least 1/3 with water (unless something
diff erent is stated on the chemical container label).
2. Turn the Manifold valve towards TurboFiller.
3. Set the fan gear lever to neutral position, engage the pump and
set P.T.O. at 540 r/min.
4. Open TurboFiller lid. Measure the correct quantity of chemical
and fi ll in the hopper.
5. Engage the hopper transfer device by opening the TurboFiller
suction valve so the chemical is being transferred to the main
tank.
6. Engage the fl ushing devise to fl ush the hopper. If powder
chemicals are fi lled the fl ushing device must be open before
pouring the powder into the hopper.
7. If the chemical container is empty, it can be rinsed by the
Chemical Container Cleaning device. Place the container over
the multi-hole nozzle and push the upper lever to the left of the
TurboFiller.
8. Close TurboFiller suction valve when the hopper has been rinsed.
9. Close the TurboFiller lid.
10. Disconnect the pressure to the TuboFiller, and keep agitation
activated to ensure homogeneous concentration.
11. Engage the fan gearbox before spraying..
DANGER! Always wear face shield and other appropriate personal safety equipment when fi lling chemicals.
ATTENTION! The scale in the hopper can only be used if the sprayer is parked on level ground! It is recommended
to use a measuring jug for best accuracy.
DANGER! In order to avoid spray liquid hitting the operator, do not press lever unless the multi-hole nozzle is
covered by a container as spray liquid may otherwise hit the operator.
ATTENTION! The rinsing device uses spray liquid to rinse containers for concentrated chemicals. Always rinse the
chemical containers with clean water several times until they are clean before disposal.
ATTENTION! The hopper rinsing device is using spray liquid for rinsing the hopper of concentrated chemicals!
Cleaning the TurboFiller must always be done when the spray job is ended and together with the entire sprayer. A
cleaning after the last fi lling and before spraying the last tankful does not ensure a clean TurboFiller!
5 - Operation
63