Chapter 2: Mechanical Specifications And Installation; Unpacking And Handling The Scan Head - Aerotech AGV-HP Series Hardware Manual

AGV-HP(O) Hardware Manual

Chapter 2: Mechanical Specifications and Installation

W A R N I N G : AGV-HP(O) installation must be in accordance to instructions provided by this
manual and any accompanying documentation. Failure to follow these instructions could result
in injury or damage to the equipment.
W A R N I N G : Do no stare into the laser beam, place your body parts in the beam path, or
expose yourself to reflections from powerful beams.
W A R N I N G : Only a Class 1 HeNe laser is recommended for performing alignments. If this is
not possible, use the lowest power setting on the available laser and employ remote beam
sensing techniques.
W A R N I N G : Wear eye protection. The danger to your eyes increases when optical
instruments are used in conjunction with the scan head.
W A R N I N G : Failure to use the parameter file provided by the factory may result in permanent
mechanical damage to the scan head.
2.1. Unpacking and Handling the Scan Head
W A R N I N G : To prevent the accumulation of condensation on the optical surfaces, allow the
shipping case to sit at room temperature before you open it.
W A R N I N G : It is the customer's responsibility to safely and carefully lift and move the scan
head. Improper handling could adversely affect the performance of the AGV-HP(O)
l
moving parts may shift and cause bodily injury.
l
l
l
l
protect the optics.
W A R N I N G : Fingerprints contain aggressive substances that can damage optical surfaces.
Always wear suitable gloves when you handle the optics.
Lift only by the base of the scan head.
Carefully remove the AGV-HP(O) from its protective shipping container. Gently set the AGV-HP(O) on a
smooth, flat, and clean surface.
www.aerotech.com
Chapter 2: Mechanical Specifications and Installation
Make sure that all moving parts are secure before moving the AGV-HP(O). Unsecured
Do not use the cables or tubing as a lift surface.
Do not use the focal lens or exit aperture as a lift surface.
Make certain that the lens cap is attached before moving the AGV-HP(O).
Only put the scan head on a soft surface when it is not attached to its mounting surface to
21