Aerotech AGV-HP Series Hardware Manual page 38

2.3. Securing the Scan Head to the Mounting Surface
A general procedure for attaching the AGV-HP(O) scan head to a mounting flange is provided below. Note
that the mounting flange must include appropriate features to match the threaded holes and the dowel holes
and slots present on the AGV-HP(O) scan head.
1. Remove the plug from the beam entrance aperture of the scan head.
N O T E : After removing the plug, retain it for future use. In the event that the scan head should require
service at the factory, the plug may be reinstalled to ensure that the scan head ships safely.
2. Prepare the mounting flange and the mating surface of the scan head by stoning with precision
flatstones to remove any burrs or high spots.
3. Clean the mounting flange and the mating surface of the scan head with the appropriate cleaners
(isopropyl alcohol for the scan head).
4. Line up the dowel hole and slot features of AGV-HP(O) scan head with the dowel pins protruding
from the mounting flange.
5. Install the scan head onto the pins.
6. Insert the appropriate hardware into the holes of the mounting flange. The screw length must be
long enough to provide at least 1.0x diameter thread engagement.
7. Using an appropriate wrench, tighten the hardware. Alternate tightening of the screws so that the
AGV-HP(O) scan head comes together evenly on the mounting flange.
38
AGV-HP(O) Hardware Manual
www.aerotech.com