Cutting Unit High Trim Height Switch - Toro Groundmaster Series Service Manual

Cutting Unit High Trim Height Switch

Adjusting the Cutting Unit High Trim Height Switch
Electrical System: Testing the Electrical Components
g306357
1. Cutting unit high trim height switch
2. Jam nut (2 each)
3. Switch bracket
The cutting unit high trim height switch is a normally open proximity switch that
closes when the lift arms are lowered. The switch mounts to a bracket on the
machine frame behind the right front wheel. The sensing element for the high
trim height switch is the sensing plate that is secured to the right side lift arm.
When the lift arm is in the lowered position, the sensing plate will be near the
switch face and the switch will be closed. When the lift arm is raised, the sensing
plate moves away from the position switch face and the switch opens.
With the key switch in the R
height switch should be illuminated when the lift arm is in the lowered position.
Use a small mirror to view the LED if necessary.
The TDM display/controller monitors the position of the high trim height switch.
Using the high trim height switch position (open or closed) and a variety of other
inputs, the TDM display/controller manages a variety of machine functions.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake and set the key switch to the O
2. The cutting unit high trim height switch should have a 3.3 to 3.8 mm (0.13 to
0.15 in) clearance between the sensing eye of the switch and the sensing
plate.
Figure 91
4. Sensing plate
5. Wire harness connector
position, the LED on the cable end of the high trim
UN
Page 6–34
position.
FF
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A