Hydraulic Tank - Toro Groundmaster Series Service Manual

Hydraulic Tank

g301600
1. Cap
2. Dipstick
3. Hydraulic tank
4. Rubber bumper (4 each)
5. Flat washer
6. Lock washer
7. Cap screw
8. Plug w/o-ring
Removing and installing the Hydraulic Tank
Hydraulic System: Service and Repairs
9. Hose – suction
10. Hose clamp
11. Suction filter
12. Drain plug w/o-ring
13. Hold down bracket
14. Plug w/o-ring
15. Hydraulic tube – return
16. Hose – vent
Refer to Figure 47 for this procedure.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
2. Empty the hydraulic tank through the drain plug at the bottom of the tank.
Use a new O-ring and install the plug when finished to prevent contamination
from entering the hydraulic system.
3. Open the hood and remove the right side hold down bracket from the ROPS.
Figure 47
17.
18.
19.
20.
21.
22.
23.
24.
Page 5–64
Tube – vent
Hose
Hose clamp (2 each)
Drop tube
Grommet
Grommet
Barb fitting
Hose clamp (2 each)
position and remove
FF
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A