Traction Pump Drive - Toro Groundmaster Series Service Manual

Traction Pump Drive

Replacing the Traction Pump Drive Belt
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
g316420
1. Idler arm
2. Drive belt
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
2. Raise the hood.
3. Use a 1/2 inch square drive on the hydraulic pump drive belt idler arm to
relieve the belt tension and remove the belt from the idler and pump pulleys.
4. Disconnect the cutting unit drive shaft at the PTO clutch.
5. Remove the clutch stop strap from the PTO clutch.
6. Guide the belt over the PTO clutch and out of the machine.
7. To install the new drive belt, follow this procedure in reverse order.
Figure 49
3. Pump pulley
Page 5–67
position and remove
FF
Hydraulic System: Service and Repairs