Air Conditioning Compressor - Toro Groundmaster Series Service Manual

Air Conditioning Compressor

g316096
1. Compressor bracket
2. Flange nut (metric)
3. Shim (as required)
4. Compressor
5. Lock nut (2 each)
6. Spacer
Replacing the Compressor Drive Belt
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
7. Ball joint
8. Jam nut
9. Spacer (3 each)
10. Washer (2 each)
11. Cap screw
12. Turnbuckle
The air conditioning compressor used on the Groundsmaster 3310 is a Sanden
model SD5H09. For air conditioning compressor repair procedures; refer to the
Sanden SD Compressor Service
Note: Replacement of the drier−receiver is recommended whenever the
compressor is serviced or replaced.
Refer to Figure 146 for this procedure.
1. Park the machine on a level surface, lower the cutting unit (or attachment),
engage the parking brake, set the key switch to the O
the key from the key switch.
Note: The jam nut at the bottom of the turnbuckle has left hand threads.
2. Loosen the turnbuckle jam nuts and rotate the turnbuckle to relieve the belt
tension. Remove the V-belt from the compressor pulley.
3. Use a 1/2 inch square drive on the hydraulic pump drive belt idler arm to
relieve the belt tension and remove the belt from the idler and pump pulley.
4. Disconnect the cutting unit drive shaft at the PTO clutch.
5. Remove the clutch stop strap from the PTO clutch.
Figure 147
13.
14.
15.
16.
17.
Guide.
Page 9–11
Jam nut – left hand thread
Ball joint – left hand thread
Cap screw
Cap screw (metric)
V-belt
position and remove
FF
Operator Cab: Service and Repairs