Control Panel And Windshield Wiper Assembly - Toro Groundmaster Series Service Manual

Control Panel and Windshield Wiper Assembly

Removing the Windshield Wiper Assembly
Installing the Control Panel and Windshield Wiper Assembly
Operator Cab: Service and Repairs
g316356
1. Wiper motor
2. Gasket
3. Mounting plate
4. Washer (2 each)
5. Lock nut (2 each)
6. Boot (2 each)
Note: If possible, operate the windshield wipers to ensure that the wiper motor
shaft is in its home position prior to disassembly.
1. Disconnect the washer supply hose and remove the wiper arm assembly.
2. Remove the 4 cap screws securing the control panel cover. Disconnect
the windshield wiper/washer switch from the wire harness and remove the
cover assembly.
3. Remove the windshield wiper boots, lock nuts, and washers from outside
the roof panel.
4. Support the wiper motor, remove the mounting plate from outside the cab,
and remove the wiper motor.
1. Fit the wiper motor shafts through the cab frame and install the mounting
plate from outside the cab.
2. Install the washers, lock nuts, and boots.
Note: The wiper motor must be in its home position prior to installing the
wiper arm assembly. Replacement wiper motors are shipped with the motor
in the home position. You may also energize and operate the wiper motor for
at least one cycle to set the motor to its home position.
Figure 149
7. Flange nut (2 each)
8. Wiper blade
9. Spacer (2 each)
10. Wiper arm assembly
11. Bracket
Page 9–14 Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A