Toro Groundmaster Series Service Manual page 299

Blade Spindle Assemblies
Groundsmaster ® 3200, 3300 and 3310
19240SL Rev A
g315082
1. Spindle assembly – Standard
2. Blade – Standard
3. Hex bushing – Standard
4. Blade bolt – Standard
5. Spindle assembly – Groundsmaster
Removing the Blade Spindle Assemblies
Refer to Figure 133 for this procedure.
1. Park the machine on a level surface, lower the cutting unit, engage the
parking brake, set the key switch to the O
from the key switch.
2. Remove the belt covers and the drive belt from the cutting unit; refer to the
cutting unit Operator's Manual.
3. Rotate the cutting unit to the S
Operator's Manual.
4. Remove the blade bolt, hex bushing or anti-scalp cup, and blade from the
spindle.
5. Remove the fasteners that secure the spindle assembly to the deck, and
remove the spindle assembly from the deck.
Installing the Blade Spindle Assemblies
Refer to Figure 133 for this procedure.
1. Position the spindle assembly to the cutting unit deck.
A. For Standard series cutting units, the spindle housing has a locating
feature that must fit into the locating hole in the deck. The bottom of the
spindle housing spacer must fit flat against the deck once installed.
Figure 133
6. Flange nut (6 or 8 each)
7. Blade – Groundsmaster
8. Anti-scalp cup – Groundsmaster
9. Blade bolt – Groundsmaster
FF
position; refer to the traction unit
ERVICE
Page 8–7
position and remove the key
Cutting Units: Service and Repairs