Top Convection Deflector; Fireplace Requirements - Travis Industries DVL EmberGlo GSR2 Insert Owner's Manual

8
Installation (for qualified installers only)

Top Convection Deflector

Install the top convection deflector as
shown to the right.
The deflector is shipped on top of the
insert. The screws are shipped inside
the owner's pack.

Fireplace Requirements


Insert must be placed within a code-conforming masonry fireplace or tested and listed factory-built
(metal) wood-burning fireplace. Repair any fireplace damage prior to installation.

Because the insert uses a circulation blower, clean the fireplace, smoke shelf, and chimney prior to
installation.

This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance
produces when determining a location.
b
f
a
e
h Attach the "This fireplace has been altered..." plate to the fireplace (use two screws or another
suitable method). You may wish to place it in a location where it will be covered by the surround
panels.
© Travis Industries
Fireplace
a
Height
b
Front Width
b
h
Rear Width
c
g
Depth
c
d
d
e
f
g
9/17/2020 - 1536
1-Piece Panel
Sizing
Minimum
24-7/8" (632mm)
Minimum
32-1/2" (826mm)
Minimum
20" (508mm)
15-3/4" (400mm)
Minimum
16-1/4" (413mm)
w/ Arched Faces
Hearth
0" (0mm)
Extension
The gas and electrical line should be installed prior to installing
the heater.
For tight fits (under 28") see the section "Removing the Vent
Connector"
See "Leveling Bolts" for details on leveling the heater.
1-Piece Panel w/
Trim
23-3/4" (604mm)
31-1/2" (800mm)
20" (508mm)
14-1/2" (369mm)
or or
15" (381mm)
w/ Arched Faces
1-1/4" (32mm)
DVL EG GSR2