Before You Begin; Remote Control Warnings - Travis Industries DVL EmberGlo GSR2 Insert Owner's Manual

Before You Begin


Read this entire manual before you use your new heater (especially the section "Safety Precautions"
on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily injury, or
even death.

Remote Control Warnings

KEEP BATTERIES AND COVER INSTALLED AT ALL TIMES
The remote control system requires the batteries and battery cover to remain in place at all times. If
you need to replace dead batteries, make sure to turn the appliance off before removing the
batteries.
NOTE: If the batteries go dead, the system will operate normally as long as household power
The transmitter and IFC are radio frequency devices. Placing the transmitter in or near metal may
severely reduce the signal range.
Turn off the main gas supply to the appliance during installation or maintenance. In case of remote
control malfunction turn off the main gas supply to the appliance.
The SIT GSR2 remote may be programmed to disable the thermostat or any of the modes (flame height, blower, light, comfort control,
Standing Pilot *, or auxiliary power input). This allows you to tailor the remote to the appliance.
* We do not recommend disabling the standing pilot option for our gas appliances. This feature may be recommended for cold regions
or installations with sub-optimal venting.
How to Disable/Enable the Thermostat
The remote is shipped with the thermostat enabled.
1 Remove one battery from the remote.
2 Press and hold the thermostat button while
replacing the battery. This will toggle the
thermostat function. Repeat this process to toggle
the thermostat function to the desired setting.
How to Disable/Enable Modes (Light, Blower, etc.)
The remote is shipped with all modes enabled (except AUXiliary).
1 Remove one battery from the remote.
2 Press and hold the on/off button and mode button while replacing the battery.
Keep the on/off button depressed during the following steps.
3 While keeping the on/off button depressed, press and release the
mode button until the mode that needs to be changed is illuminated.
4 With the desired mode illuminated (see illustration to the right),
press the "up" or "down" button to activate or clear the mode being
addressed. Make sure to keep the on/off button depressed during
this process.
5 Release the on/off button to complete programming.
© Travis Industries
Operation
(120VAC) is present.
PROGRAMMING THE REMOTE
9/17/2020 - 1536
"SET" = thermostat
function enabled.
"CLR" = thermostat
function disabled.
Standing
Flame
Pilot
Height
Optional
Blower
Comfort
Accent
Light Control
"SET" = selected
mode enabled.
"CLR" = selected
mode disabled.
DVL EG GSR2
29
AUX