28
9.
Check the air shutter following the directions below.
Air Shutter Adjustment
Let the heater burn for fifteen minutes (make sure the logs and glass are in place). The flames should be
yellow with no sooting. Adjust the air shutter, if necessary, to achieve the correct looking flame.
Correct
Flames should be blue at the
base, yellow-orange on the top.
10. Attach the face following the directions included with the face.
11. Adjust the flame to its highest position - the flames should not contact the top of the firebox. Check the flame on low
position. The flames should burn off of each burner hole. If the heater does not work correctly, contact your Travis dealer
for a remedy.
12. Give this manual to the homeowner for future reference and fully explain the operation of this heater.
© Travis Industries
Finalizing the Installation
Not Enough Air
If the flames are too tall or sooty on the
ends, open the air shutter.
Rear Burner Air Shutter Control
9/17/2020 - 1536
If the flames are all blue and
short, close the air shutter.
Front Burner Air Shutter Contro
(GOLD)
Left = More Air
Right = Less Air
Too Much Air
(RED)
Left = More Air
Right = Less Air
DVL EG GSR2